Crystal Industrial’s High Pressure Access Systems from India
System Overview
Crystal Industrial’s High Pressure Access Systems from India are special pipe arrangements which allow inward access to manufacturing plant vessels and pipework working under full operative conditions. The corrosion checking industrial standard for these type of access systems depends on a 2-inch minimal bore design.
Crystal Industrial’s Plug Assemblies from India
Crystal Industrial’s Plug Assembly from India is the recoverable bearer; it holds corrosion monitoring, chemical injection or different devices which may be set up through the access fitting. There are two specific sorts of fitting assemblies – the Solid Plug and the Hollow Plug.
Crystal Industrial’s Plug Assembly from India fits into the opening of the access fitting body and is intended to close the fitting against line pressure. When Crystal Industrial’s access fittings from India are being used, a pipe attachment or nipple and shut-off valve is likewise required to close the fitting.
The majority of the Crystal Industrial’s Plug Assemblies from India are independently pressure tried at the manufacturing plant and are assessed for operation at high pressures.
Crystal Industrial’s Solid Plugs from India
Crystal Industrial’s Solid Plugs from India transmit coupon holders, bioprobes, sand probes and injection/sampling systems.
The solid plug nut is expelled from the bottom of the fitting and supplanted by the device being established.
A left-hand thread is used to ascertain that installed devices are not loosened in the midst of the retrieval procedure.
Components
- Pipe Plug – Protects inward threads and gives subsidiary backup seal. Should be emptied in the midst of retrieval operations.
- Solid Plug Body.
- O-Ring Seal.
- Basic Packing Seal.
- Strong Plug Nut – Only used when no other device is joined.
Crystal Industrial’s Hollow Plugs from India
Hollow Plugs are used with electrical resistance probes, direct polarization resistance probes, and hydrogen probes.
To connect these devices, the hollow plug seal nut is removed and the observation device is fixed into the female thread at the base of the hollow plug. A left-hand thread is used. Access is allowed through the highest point of the hollow plug for electrical fittings to be made directly to probes to take to readings.
Components
- Thread Protector – Must be emptied in the midst of retrieval operations.
- Hollow Plug Body.
- Primary Packing Seal.
- Hollow Plug Nut.
- Device Seal.
- Bore Seal Nut – Only used when no other device is connected.
Establishing and Orienting Crystal Industrial’s Plug from India
If the corrosion monitoring device needs circular placement with the product flow (coupon holder, LP probe, injection quill, etc.), you should record a notch on the highest point of the hex. The notch must be documented so that the gadget can be adjusted to the product flow.
Apply an appropriate oil to the whole length of the fitting. If attaching the plug in pressure, use Crystal Industrial’s Retriever Tool and Service Valve from India.
If connecting the plug manually, thread the plug assembly into the access fitting body. Do not use additional power and ensure that the threads draw in suitably to prevent cross-threading.
The reference stamp should now be changed in accordance with product stream course. Turn the plug assembly hex clockwise till the mark adapts to the stream course.
Ascertain that the fitting is purified and dry, and place the thread safeguarding pipe fitting to the highest point of the plug.
Apply nonstop cover beads to cover the bevel. Hot tapping will be crucial for lines in service.